METAL & TIMBER FRAME WALLS
|Vertical studs are at 600mm, noggins at 600mm.|
Board edges must be supported by noggin.
Cut around all penetrations.
Use 8 galvanized screws per m², min. 30mm from edges.
Screws to be tightened till washers bite the board surface then level the washerb with a rubber mallet.
Cover joints by self adhesive fibreglass tape embedded in a layer of flexible tile adhesive.
Once the adhesive has hardened tiles can be fixed and grouted.
|For waterproof construction all joints, penetrations and fastener locations must be treated by approved polyurethane waterproofing agents as per manufacturer's recommendation. If high water pressure is expected surfaces has to be also waterproofed.|
BRICKS & CONCRETE WALL